Garage floor space is at a premium so I decided to stop using my current saw horses as a permanent stand and design and weld together a stand with a smaller foot print while leaving room for some future enhancements. My first pass at a design was larger and had more feature rich but I finally had to make the call between immediate benefit, time to build and cost. I ended prioritizing space savings and low time to build over all the fancy stuff even though the fancy stuff would have been fun to build.
Here is the basic but completed frame. Still need to cleanup some welds and paint it. I am thinking about adding some hangers below the top rails to hold blades. I'll save that for the future for now.
And some pics of some details. Nothing fancy - did go with some larger wheels for this after finding the smaller ones were such a pain to use on my welding cart.
Used the square tube as a guide for a 6" bolt which is used as an adjustable foot. I probably should top the tube to keep debris out of it - it would be hard to clear out once in there.
Here is the nut welded to the tube. These are galvanized so I had to be careful to stay out of the fumes - a slight breeze was helpful. I made the tack welds with the bolts in so the bolt was able to act like a heat sink which I do think helped.
Here is the result with the miter saw on top and some 3/4" plywood in the bottom.
This was a pretty easy project and did help me recover some floor space. With a few add-ons like blade holders, it should help organize things even more.
The main challenges with this project was accurate cuts and keeping things square during welding. I suspect I will continue to struggle with accurate cuts until I purchase something more appropriate than a 4 1/2" angle grinder. I will say that I think the angle grinder could work better if I had a large stable platform to clamp to while cutting. If I somehow can clear out and rearrange the garage someday maybe.
As for keeping things square, that also involves an appropriate platform. My homemade welding table/cart did ok for building the top and bottom separately but I found it quite challenging to keep the verticals square. My mix of square tubing and angle iron didn't make it easier. I like some aspects of using the angle iron (gives a little extra weight down low) but it was more challenging trying to get it clamped just right. For this project, I ended up using some aluminum squares and a piece of flat bar - the flat bar was used as a temporary vertical stop for the vertical rails and the 2 squares were clamped on the 2 edges of the base (did same for top) to maintain 90 degrees between the leg and top/bottom. If building more than a few things like this, it would likely be worthwhile building or buying some type of jig to get decent and repeatable results.
Other future enhancements may include folding side extensions. This would be useful when cutting longer moulding and and such.
Hope God blesses your day.
Scott
No comments:
Post a Comment